monomer concentration

High irradiation dose, monomer concentration, inflated with nitrogen increased chloramphenicol degrading efficieney;

辐照剂量高，单体浓度低和充氮，降率高；

互联网

The effects of initiator concentration, monomer concentration and temperature on the homopolymerization have been discussed.

讨论了引发剂浓度、单体浓度、温度对均聚合的影响。研究了两个单体均聚合反应动力学，提出了两个单体均聚合反应动力学方程。

互联网

The influence of the monomer concentration, reaction temperature, concentration of initiator and retention time on the grafted ratio was studied.

通过对聚丙烯进行官能化，并主要研究了反应单体浓度、反应温度、引发剂浓度和停留时间对接枝率的影响。

互联网

Kinetic studies show that polymerization proceeds with first-order dependence on both monomer concentration and initiator concentration.

聚合反应的动力学实验表明单体和催化剂浓度对该聚合反应的反应速率都表现为一级。

互联网

With increasing reaction time, monomer concentration and photoinitiator content, the diameter of particles with polymer brushes increased.

含高分子刷的微球尺寸随着反应时间、单体浓度以及光引发剂用量的增加而增大。

互联网

The effects of monomer concentration, reaction temperature, initiator dosage on polymerization rate and intrinsic viscosity of product were investigated.

探讨了单体浓度、反应温度、引发剂用量等因素对聚合反应速率和产物特性黏数的影响。

互联网

The effects of initiator concentration, monomer concentration, starch concentration and temperature on the percentage of graft were investigated.

考察了引发剂浓度、单体浓度、淀粉浓度和反应温度时接枝率的影响。

互联网

The grafting percentage increases with the increasing of reaction time and monomer concentration.

反应时间长，单体浓度高，接枝率越高。

互联网

Investigated the influence of monomer concentration, initiator concentration, reaction temperature and time on grafting efficiency.

丙烯酰胺接枝共聚物，对单体浓度，引发剂浓度，反应温度和反应时间对接枝率的影响进行了研究。

互联网

The inverse microemulsion polymerizations at the high monomer concentration

高单体浓度下反相微乳液聚合

互联网

It was shown by experiment that the reaction temperature and time, as well as the monomer concentration, had great effect on the reaction.

实验表明：反应温度、反应时间和单体浓度对接枝共聚反应影响很大。

互联网

The influence of monomer concentration on membrane performances for dehydration of ethanol was systematically studied.

系统研究了接枝单体浓度对膜的渗透蒸发分离性能的影响。

互联网

The relationships of molecular weight and monomer concentration, initiator concentration show that the polymerization reaction system has the characteristic of living polymerization.

分子量与单体浓度、引发剂浓度的关系说明，该体系具有一定程度的活性聚合特点。

互联网

When the monomer concentration increased, the grafting rate, initial polymerization rate and final conversion rate increased, but the grafting efficiency decreased;

单体浓度上升，接枝率、初始聚合速率和最终转化率也上升，但接枝效率则下降；

互联网

It was found that conversion and molecular weight were decreased with the increase of monomer concentration.

研究发现：随单体浓度的升高，转化率和分子量同时下降。

互联网

Besides, it was also found that the wave length was related to the monomer concentration as well as to the concentration of active species.

280nm左右。此外，还发现吸收峰波长与活性种浓度和单体浓度有关。

互联网

The influencing factors such as granularity of raw materials, dosage of initiator and monomer concentration was discussed.

讨论了原料粒度、发剂用量以及单体浓度等因素对反应的影响。

互联网

The relationship between ratio of graft and cerousion concentration, monomer concentration, temperature of reaction were discussed.

讨论了接枝率与铈离子浓度、单体浓度、温度的关系；

provided by jukuu

Effeets of monomer concentration and reaction time on the graft copolymerization were studied.

考察了单体浓度、发剂浓度、合温度对接枝共聚反应的影响。

互联网

Monomer concentration, 40% ( water system), respectively.

单体浓度为40%（水相）。

互联网

With the increase of monomer concentration, polymer particle size increases.

随着单体浓度的增大，聚合物粒子的粒径随之增大。

互联网

The effects of polymerization conditions, such as initiator concentration, monomer concentration, reaction time and temperature, on grafting parameters were studied.

研究了各种聚合条件如：引发剂浓度、单体浓度、反应时间、温度等对接枝参数的影响。

互联网

The influence on the water absorbing capacity, such as monomer concentration, effect of catalyst, and initiator concentration, were investigated.

文中研究了单体浓度、催化剂效果、引发剂浓度对吸水能力的影响。

互联网

The results show that the reaction rate is in direct proportion to one power of monomer concentration and a half power of initiator concentration;

实验结果表明，在聚合反应初期，聚合反应速率与引发剂的浓度呈半级反应，与单体浓度呈一级反应；

互联网

The graft polymerization processes could be controlled by monomer concentration, UV-irradiation time and photoinitiator concentration.

接枝聚合过程可以通过改变单体浓度、紫外辐照时间以及光引发剂浓度来进行调控。

互联网

Studies on Preparation of Superabsorbent at a High Monomer Concentration

高单体浓度下自交联型聚丙烯酸盐类超强吸水剂的合成研究

互联网

The effects of radiation environment, radiation dose, monomer concentration and reaction temperature in terms of grafting parameters were investigated systematically.

系统研究了辐射气氛、辐射总剂量、单体浓度以及聚合反应温度对体系接枝参数的影响。

互联网

Grafting temperature and monomer concentration were investigated.

探讨了预辐照剂量，辐照气氛，接枝反应温度以及单体浓度对接枝共聚反应的影响。

互联网

The other preparation conditions, such as monomer concentration, temperature, and time of polymerization, were systematically studied.

本文还对其它制备条件，比如单体浓度，温度，聚合反应时间都进行了系统研究。

互联网

The structure of the complex is determined by pH value and monomer concentration.

体系pH值和单体浓度是影响络合物结构的关键因素。

互联网